in the table
3.2
below.
Preliminary steps
1.
Unpack the TX50e analyzer. Check for the purchased items and any possible damage as the result of
shipment. Note: If there is any damage please contact VeEX customer service or the freight forwarder.
2.
After unpacking, keep the instrument in normal environment conditions for at least 2 hours.
3.
Plug the power supply unit into a mains electricity socket.
Before first use charge the internal battery for at least 30 minutes.
Maximum recharging time is about 8 hours. During battery recharging the instrument can still be used
normally.
NOTE: Installation of internal battery pack has to be done at the service center only.
4.
When the power is on, the test set performs a self-diagnosis. When the self-diagnosis successfully
completes, the screen will display the Home menu.
Operation
Main menu
User interface of the TX50e test set is a system of menus which provides easy and quick access to any
application. The Home menu screen is shown at Figure
5.1
.
Use the cursor to navigate the menu.
Line interface
: Operational modes settings. Before operation, it is required to define parameters in this menu.
Test pattern
: Test pattern parameters settings.
Table 3.2:
USB-cable connector
TX50e
Signal
PC
1
+5V
1
2
D-
2
3
D+
3
4
GND
4
Figure 5.1:
Home menu
Page 12 of 30
TX50e e-Manual D07-00-009 REVA00
