7-9
7
Component Removal
Removing The Printer/Blank (Left) Door
15.Notice that there are two male connectors on the bottom of the AC Input Filter board that plug into two female
connectors on the Power Supply board. With the handle (item 3 of Figure 7-9) of the AC Input Filter against the
left side of the console housing, line up the two AC Input Filter bottom connectors over the two female
connectors (items 4 and 5 in Figure 7-10) on the Power Supply board and push down on the AC Input Filter
until the connectors are firmly seated.
16.Place the Power Supply shield (item 2 in Figure 7-9) over the Power Supply board and lower it down onto its
two retention pins (see item 2 in Figure 7-11) and snap it into place.
17.Install the three T15 screws in the AC Input Filter (see item 1 in Figure 7-9).
18.Replace the AC Channel cover and install the two T15 screws (see Figure 7-8).
Figure 7-11. Replacing Power Supply shield over Power Supply board
Removing The Printer/Blank (Left) Door
1. Perform all of the Steps in the section entitled “Before Turning Off Power” on page 7-2.
2. Open the console doors as described in Step 1 of the section entitled “Removing The Ack Switch Panel/
Display (Right) Door And CPU Board” on page 7-3.
Legend For Figure 7-11
Item
Description
Item
Description
1
T15 screws
2
Board retention snap pins
2
1
