Veeder-Root TLS-450PLUS, Руководство по устранению неисправностей

Страница: 55 / 127

7-3
7
Component Removal
Removing The Ack Switch Panel/Display (Right) Door And CPU Board
Removing The Ack Switch Panel/Display (Right) Door And CPU Board
To remove just the Acknowledge Switch Panel door (or optional Display door), complete Steps 1 - 6 in this
section. To remove the CPU board, complete all Steps (1-10) in this section.
1. Remove the both left and right door screws and swing doors open to the left (see items 2/5 in Figure 2-1).
2. For the Ack Switch panel door remove the Ack Switch Panel cable plug from its CPU board connector (item 16
in Figure 2-11 on page 2-10).
For the optional Display door, remove the Display cable (pointer 1 in Figure 7-3) from the CPU board
connector. Rotate the locking member of the cable’s Display connector (1a pointer) up 90° from the
connector’s fixed base and slide cable end out.
3. Remove the LED Back light cable (pointer 2) from CPU board connector (see Figure 7-3).
Figure 7-3. Remove Optional Printer And Display Cables From CPU Board
4. Remove the Ground wire at the top of the door (see Figure 7-4).
1
4
2
3
1a