Page
30
TO START A PLLD TEST
In the Operating mode, press
Function
until the display reads:
Press
Step
and the display reads:
Press
Step
to accept all lines. To select a single line, press
Change
until
you see the line you want, then press
Enter
and
Step
. The display below
appears:
This step lets you select a 3.0, 0.2, or 0.1 gph (0.38, 0.76, 11.3 lph) line
leak test to run on the selected line(s). If your console does not have 0.2 or
0.1 gph test options, you will not see these selections.
START LINE PRESSURE TEST
PRESS <STEP> TO CONTINUE
SELECT LINE
ALL LINES
SELECT TEST TYPE
3.0 GPH
To select a 3.0 gph test, press
Step
, or press
Change
to select a
0.2 or 0.1 gph test, then press
Enter
.
To select a 3.0 gph test, press
Step
. The display reads:
To run the selected test, press
Step
. The system displays the mes-
sage (in this example for all lines):
Press
Enter
to begin the test. The system displays:
To exit this function, press
Step
.
3.0 GPH
PRESS <STEP> TO CONTINUE
START LINE TEST: ALL LINE
PRESS <ENTER>
Q#: RUNNING PUMP
PRESS <STEP> TO CONTINUE
Pressurized Line Leak Detection Tests
(PLLD Option)
