LVP615D series user manual
Chapter 6: Setup menu instructions
6.8.3 EXT. Input Model
The option is used to configure extended module after replacing it, to make sure the module can
work normally. Operation is as below:
Entering “8.3 EXT. Input Model” option, rotate knob to select relative option, press OK button to
save. The setting will be active after restarting.
6.8.4 De-Interlace
This option is used to remove trembles, which might happen when inputs are
CVBS/S-Video/HDMI/SDI signals interlace signals (e.g.: 1080i) and used as PIP. Operation is as
below:
Enter “8.4 De-Interlace”, rotate knob to select “On”, press “OK” button to make setting active.
6.8.5 Brightness Level
According to different demands, user can select relative “Bright Level”.
“8.8 Device Reset” will not change the parameter of “bright level”. When multiple units doing
cascading splice, all units must be same “bright level”. Operation is as below:
Enter “8.5 Bright Level”, rotate knob to select “0-64” or “0-100”, and press “OK” button to confirm the
setup.
Bright level
Description
0-64
0 is minimum brightness, 64 is default standard brightness.
0-100
Allow higher brightness value: 0 is minimum and 50 is default value.
