![background image](http://html1.mh-extra.com/html/vdo/ms-4300-owners-manual/ms-4300-owners-manual_owners-manual_3722953051.webp)
■
Level
Setting the input amplification for telephone output.
Settings:
❑
0 ... 15
: Adjusting the telephone input amplification.
✎
It is only possible to configure the input amplification during a telephone call.
To do this, select “Input” under “Telephone –> Input” and make the correct set-
tings for the muting signal.
✎
If the telephone output is distorted decrease the value of the input amplification.
■
Default vol.
Setting the volume which an incoming call begins with.
Settings:
❑
5 ... 40
: The call will be transmitted at the volume set.
System settings
☞
Select “System” in the setup menu.
✔
The “SYSTEM” setup menu appears.
The following functions are available:
■
System info
Information about the software and hardware version (for service purposes).
Settings: No settings available.
■
Installation
Submenu for configuring and testing the system during installation (also see installa-
tion instructions).
Settings:
❑
Syst. status
: Displays information on the GPS reception (GPS status, number of satel-
lites), the speedometer signal (speed impulses), the temperature in the unit and the
direction signal (forwards/ backwards).
❑
Direction
: Adapting the switch input for direction detection.
High
: “Active high” backwards signal (12 V).
Low
: “Active low” backwards signal (0 V).
❑
Speaker test
: Confirm to start the speaker test. A sound should be heard on all four
loudspeakers, one after another.
❑
Mount. angle
: Adapting the unit to the mounting position in the vehicle. Also see in-
stallation instructions.
❑
Car position
: Display of current vehicle position (street, country code and city as well
as the GPS position). The city and street will only be displayed if the vehicle is on a
digitised road.
■
Service
Code-protected menu for the analysis of hard and software problems (only for author-
ised service personnel).
Settings: None
Setup
50