Marquee 8521 Ultra Green (HUD) User's Manual
2-8
Installation
&
Setup
Note:
The source connected to the currently selected input should now be visible. If there is no picture,
check to see if the source is active.
Step 12.
Press [
▲
] or [
▼
], [
◄
] or [
►
] to adjust
phase until the picture is centered on the
screen.
Step 13.
Press [
▲
] or [
▼
], [
◄
] or [
►
] to adjust the
size of the picture. Ensure that objects in
your picture have the correct shape. For
example, if there is a circle in your picture,
size should be adjusted until the circle is
round, not oval.
Before
After
Before
After
Note:
Remember that all of the adjustments above should be repeated for other sources in the system.
2.7 Memory
Setup
This section explains how to set up projector memories to improve the performance of the projector's ASI and
ASR features. If you are not familiar with setup memories, read 0, prior to memory setup; in particular, read
Section3.3, Setup Memories, and the ASI with Save and Turn ASR On/Off entries in Section 3.6, Utility Features.
If the projector's setup memories are properly set up, the projector will be easier to use and operate.
Note: Memory setup should be performed when the projector is in its final operating position. If the physical
position of the projector changes, memory setup must be repeated.
Here is a brief summary of the setup memory, ASR, and ASI discussions in 0
2.7.1 About Setup Memories
The projector has 80 setup memories for storing display settings of different sources. Multiple setup memories
are required since display settings usually vary amongst sources. There are two types of setup memories: Input
and Recall. Both memory types store the same parameters. The only difference is that Input memories store
display settings for a particular physical input (e.g., switcher 0, slot 1) while Recall memories can be used with
any input.
At any one time, one setup memory is the current setup memory. The display settings in the current setup
memory are used for the current display. When a source is selected by entering its input number, the Input
memory for the selected input becomes the current setup memory*. If a Recall memory is selected, it becomes
the current setup memory*. Display adjustments are automatically saved in the setup memory which is current at
the time of adjustment (unless the setup memory is locked).
Note:
If the ASR feature (explained below) is turned on during setup memory selection, the selected memory
may not be the current setup memory.
To display the Recall memories stored in the projector, press [
UTIL
] [
3
]. Press [
UTIL
] [
4
] to display the Input
memories. (Unused setup memories are not displayed).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
