2-1
Section 2 Installation & Setup
This section explains how to install and set up the projector. If you are familiar with the projector and want to
quickly set it up for temporary use, follow the Quick Setup instructions in Section 2.1. For a complete setup, skip
Section 2.1 and follow the instructions and guides covered in the remaining subsections.
2.1 Quick
Setup
Follow these 7 steps for quick set up of the projector:
Step 1.
Position the Projector
To perform a quick setup, the projector must be positioned so that the throw distance is the same
as that used during the most recent optical alignment; otherwise a detailed setup is required. The
throw distance is the distance between the center lens on the projector and the center of the
projection screen.
Note:
If an optical lens alignment is required, refer to Section 2.5, Optical Alignment.
Step 2.
Connect the Power Cord
Plug the AC line cord into the line input unit on the electronic chassis. Plug the three prong end
of the line cord in a grounded AC outlet.
Note:
Input voltage must be between 90 VAC and 264 VAC.
Note:
Ensure the line cord is the proper type for the AC receptacle.
Step 3.
Connect a Source
Connect a source to the projector's built-in RGB input (slot 1). Ensure the source is on and
properly connected.
Step 4.
Turn the Projector On
Press [
POWER
] on the keypad to turn the projector on. Hold down the power key for about one
second.
Note:
If the keypad has been configured for IR remote operation, point it towards the screen or the front of
the electronic chassis.
Step 5.
Select the Input
Press [
SOURCE
] [
0
] [
1
] to select the source connected to the built-in RGB input. Or, if installed
with the optional image shift, press [
SOURCE
] [
0
] [
2
] to select the source connected to the Image
Shifter input.
Step 6.
Adjust the Display
Press [
HELP
] [
1
] to select the Guided Source Setup tutorial.
2.2 Keypad Operating Settings
The keypad includes its own memory to store keypad operating settings. With a few simple keystrokes you can
over-ride the "hard wire" protocol setting (explained earlier) and enable or disable the backlit feature. Keypad
battery life is increased if the backlit feature is disabled. The new operating settings are stored in the keypad until
the batteries are replaced (IR remote keypad) or the keypad connection cable is unplugged (wired).
If the keypad is configured for IR remote operation, make sure the batteries are installed. If it is configured for
wired remote operation, make sure its extension cable is properly connected to the projector. Perform the
following keystroke sequences to change its operating settings:
•
To toggle the keypad's protocol setting (A or B), press [
] [
BRITE
] [
TINT
] [
DETAIL
] [
1
].
•
To toggle the backlit feature (enable or disable), press [
] [
BRITE
] [
TINT
] [
DETAIL
] [
3
].
•
To return all configuration settings to the jumper settings, press [
] [
BRITE
] [
TINT
] [
DETAIL
] [
0
].
Note:
The projector will not respond to keypad commands if you press [
] [
BRITE
] [
TINT
] [
DETAIL
] [
2
]. If
pressed accidentally, press [
] [
BRITE
] [
TINT
] [
DETAIL
] [
0
] to clear all keystroke settings.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
