Varifan DIP-1C, Инструкция по установке и эксплуатации

Страница: 23 / 42

DIP-1C USER’S GUIDE
DIP-1C Section C-23
Normal Mode Settings
Winter Minimum Position (POS 1)
These parameters will only appear if the outside temperature is used on at
least one of the units connected to the DIP-1C.
Winter Minimum Position
This parameter is used to adjust the minimum opening position when the
Outside Temperature is equal to or below Winter Temp . When the
Outside Temperature is between Winter Temp and Summer Temp , the
minimum opening position will modulate accordingly. The calculated
minimum opening is displayed at the unit 1
Variable 1 Start Position
parameter. This parameter is adjusted in 1% increments from 0% to 100%.
Winter Temp
This parameter is used to set the temperature at which minimum opening
position will be equal to
Winter Minimum Position . When the Outside
Temperature is between Winter Temp and Summer Temp , the minimum
opening position will modulate accordingly. The calculated minimum
opening is displayed at the unit 1
Variable 1 Start Position parameter. This
parameter is adjusted in 0.1° increments from -58.0°F to 140.0°F (-50.0°C
to 60.0°C).
Summer Minimum Position (POS 2)
These parameters will only appear if the outside temperature is used on at
least one of the units connected to the DIP-1C.
Summer Minimum Position
This parameter is used to adjust the minimum opening position when the
Outside Temperature is equal to or above Summer Temp . When the
Outside Temperature is between Summer Temp and Winter Temp , the
minimum opening position will modulate accordingly. The calculated
minimum opening is displayed at the unit 1
Variable 1 Start Position
parameter. This parameter is adjusted in 1% increments from 0% to 100%.
Summer Temp
This parameter is used to set the temperature at which minimum opening
position will be equal to
Summer Minimum Position . When the Outside
Temperature is between Summer Temp and Winter Temp , the minimum
opening position will modulate accordingly. The calculated minimum
opening is displayed at the unit 1
Variable 1 Start Position parameter. This
parameter is adjusted in 0.1° increments from -58.0°F to 140.0°F (-50.0°C
to 60.0°C).
www.monitrol.com