DIP-1C USER’S GUIDE
Section C-26
DIP-1C
Unit 2 Variable Position (POS 5)
These positions will only appear if unit 2 is activated by setting DIPSW2 to
ON (see DIP Switches and Slide Switches Table page 36).
Variable 1 Start Position
1-STR
This parameter is used to establish the position the inlet will take when
variable 1 of unit 2 runs at its minimum speed. When variable 1 of unit 2
runs above its minimum speed, the inlet’s opening will modulate from this
position to
Variable 1 End Position
. This parameter is adjusted in 1%
increments from 0% to 100%.
Variable 1 End Position
1-END
This parameter is used to establish the position the inlet will take when
variable 1 of unit 2 runs at its maximum speed. This parameter is adjusted
in 1% increments from 0% to 100%.
Variable 2 Start Position
2-STR
This parameter is used to establish the position the inlet will take when
variable 2 of unit 2 runs at its minimum speed. When variable 2 of unit 2
runs above its minimum speed, the inlet’s opening will modulate from this
position to
Variable 2 End Position
. This parameter is adjusted in 1%
increments from 0% to 100%.
Variable 2 End Position
2-END
This parameter is used to establish the position the inlet will take when
variable 2 of unit 2 runs at its maximum speed. This parameter is adjusted
in 1% increments from 0% to 100%.
www.monitrol.com
Содержание DIP-1C
