CB-800
CB-1000
2.5.4 B
RUSH
DRIVE
Make sure all the persons, children, and animals are located at a SAFE distance from the machine! Otherwise, do
not continue in any future activity!
Check for any solid obstacles in the area behind you.
•
To start and stop the travel, use the
brush drive pulley lever
1
(in
Fig. 3
) on the right handle.
2.5.4.1 B
RUSH
DRIVE
START
1.
Set the maximum engine speed with the
accelerator lever
5
(in
Fig. 3
).
2.
Grab the left handle of the handlebar with your left hand.
3.
Press the control lever on the right handle in a smooth, slow motion with your right hand.
Beware of sudden reverse movement of the machine caused by counter-rotation of the brushes.
4.
Once the brushes start rotating, squeeze the lever and hold it and the handle firmly.
Always press the clutch lever up to the handlebar handle. If the lever is not fully pressed, the V-belt gets
damaged.
With a new or cold engine, the first few times the brush drive is started, the engine may stall. When the engine has warmed
up, this will no longer happen. If the brush drive cannot be started even after the engine has warmed up, check for any of
the faults in
on
page 38.
Brush starting may be accompanied with partial slipping of the V-belt and associated accompanying phenomena (rattling,
whistling). When the belt has been run in, these effects usually disappear.
If the problem persists, it is necessary to adjust the belt tension - see
Chap.2.7.7.3 Brush drive pulley adjustment
on
page 36.
2.5.4.2 S
WITCHING
OFF
THE
BRUSH
DRIVE
•
The brush drive switches off after you release the lever on the right handle.
Never use your hand stop the reverse movement of the lever!
Always switch off the engine before carrying out any work near the machine.
Never leave the engine running at maximum speed or idling for a long time with the brush drive switched off! Parts of the
drive train (V-belt, belt pulley, tensioning pulley, etc.) may get damaged!
2.5.5 M
ACHINE
TRAVEL
Make sure all the persons, children, and animals are located at a SAFE distance from the machine! Otherwise, do
not continue in any future activity!
The travel clutch is a belt clutch, the machine starts smoothly, without jerking.
•
To switch on and off the machine travel, use the
travel pulley lever
2
(in
Fig. 3
) on the left handle.
2.5.5.1 S
TARTING
1.
Push the lever to the handle, and the machine will immediately move forward.
2.
Once you press the lever and the machine starts moving forward, adjust your walking speed to the machine speed!
Always press the travel clutch lever all the way to the handlebar handle. If the lever is not fully pressed, the V-
belt gets damaged.
Never use the travel lever to adjust the travel speed! The V-belt gets damaged.
2.5.5.2 S
TOPPING
Beware of sudden reverse movement of the machine caused by counter-rotation of the working tool when the
machine is switched off.
•
The machine stops only after you release the lever on the left handle.
Never use your hand stop the reverse movement of the lever!
Always switch off the engine before carrying out any work near the machine.
Never leave the engine running at maximum speed or idling for a long time with the brush drive switched off! Parts of the
drive train (V-belt, belt pulley, tensioning pulley, etc.) may get damaged!
29
re
vi
ze
1
2/
20
21
