VAN'S AIRCRAFT, INC.
PAGE:
REVISION:
DATE:
01/19/19
0
RV-12iS
42PiS-14
19X MATCH-DRILL #40
10X MATCH-DRILL #27
IGNORE THIS HOLE
DIMPLE #40 ALL RIVET HOLES
FLUSH THIS SIDE
23X MACH CSK
FLUSH THIS SIDE
FIGURE 1: LOCATING THE F-00063
FIGURE 2: MATCH-DRILLING THE F-01202B-1
FIGURE 3: PREPARING THE F-01202B-1
FIGURE 4: COUNTERSINKING THE F-00063-L
(MIRROR FOR F-00063-R)
Step 1: Cleco the F-00063 Doubler to t he aft side of the F-01202B-1 Panel Base flange as shown in Figure 1.
NOTE: Do not match-drill the #27 hole noted in Figure 2 into the F-00063. This hole is not used for the G3X Touch installation.
NOTE: The two upper screw holes in the F-00063 will make notches in the F-01202B-1 flange. See Figures 2 and 3.
Step 2: Match-Drill #27 and #40 all holes not found in the F-01202B-1 using the F-00063 as a guide. See Figure 2.
Step 3: Remove the F-00063 and deburr.
Step 4: Dimple all rivet holes in the F-01202B-1 flange as shown in Figure 3.
Step 5: Machine countersink all rivet holes in the F-00063 as shown in Figure 4. This is now the F-00063-L.
Step 6: Mirror all steps on this page for the right side of the aircraft to fabricate an F-00063-R.
CLECO AS REQUIRED
F-01202B-1
F-00063
F-00063
F-01202B-1
F-01202B-1
