42PiS-05
RV-12iS
0
01/19/19
PAGE:
REVISION:
DATE:
VAN'S AIRCRAFT, INC.
PLASTIC TIE-WRAP 5.5"
2X PLASTIC TIE-WRAP 5.5"
F-00204
NAV ANTENNA CONDUIT
Step 1: Drill #19 a hole in the VS-1208 Rib at the location shown in Figure 1.
Step 2: Fabricate the F-00204 Nav Antenna Conduit by cutting a piece of NT Duct 5/8 to a length of of 44 1/2 in. [113 cm].
Step 3: Route the F-00204 through the aft-most set of lightening holes in the ribs of the V-Stab Assembly. See Figure 2.
Step 4: Secure the F-00204 to the ES-00301 on the top of the V-Stab Assembly.
The F-00204 should extend approximately 1/4 in. [6.4 mm] past the ES-00301. See Figure 2.
Step 5: Secure the bottom of the F-00204 to the VS-1208 using two crossing tie-wraps through the hole in the VS-1208 as
shown in Figure 2.
FIGURE 2: INSTALLING THE NAV ANTENNA CONDUIT
V-STAB ASSEMBLY
DRILL #19
5/8 [15.9 mm]
FROM EDGE
VS-1208
FIGURE 1: DRILLING THE V-STAB RIB
LEFT
UP
FWD
