Vanner IQ12-2600, Руководство пользователя

Страница: 18 / 44

VANNER POWER GROUP VANNER POWER GROUP IQ SERIES IQ SERIES
- 18 - IQ SERIES OWNERS MANUAL
2.18 (18) PROGRAMMING CONTROL SWITCHES
Located on the top right corner of the control circuit board is a 10 position DIP switch containing
the 10 individually numbered slide-type Programming Switches in one housing. All switch
functions are described below and on the label inside the front cover.
IQ Models (Inverter only)
Only Switch 2 of the Programming Switch is functional on IQ Models and is used to enable or
disable the Load Demand Feature.
IQC Models (Inverter/Charger)
All positions of the Programming Switch are functional on IQC Models.
Item Switch Number Left / Right Position Function
2.18.10 10 Add 64 (32) amps / 0 12Volt (24V) Bulk charge rate
2.18.9 9 Add 32 (16) amps / 0 12Volt (24V) Bulk charge rate
2.18.8 8 Add 16 (8) amps / 0 12Volt (24V) Bulk charge rate
2.18.7 7 Add 8 (4) amps / 0 12Volt (24V) Bulk charge rate
2.18.6 6 90VAC / 77VAC Low AC Input Voltage switchover
tolerance value.
2.18.5 5 Disable / Enable Disable Inverter operation. While the
inverter is disabled the battery charger
and transfer switch remain operational.
2.18.4 4 Disable / Enable Disable Charger operation. The charger
will be disabled only if the inverter is
also disabled at dip switch 5. The
transfer switch remains operational.
2.18.3 3 Start / Off Equalize Start
2.18.2 2 Enable / Disable Load Demand
2.18.1 1 Gel / Wet Battery Type
2.19 (19) 120 VOLT AC WIRING TERMINAL STRIP
CAUTION: BE SURE THE INVERTER IS TURNED OFF AND ALL EXTERNAL SOURCES
OF POWER ARE TURNED OFF BEFORE ACCESSING THE AC
INPUT/OUTPUT WIRING TERMINAL STRIP.
General
AC output and input wires will enter through the three (3) strain relief cable clamps located on the
right side of the unit.
The installer should verify that all AC circuits connected to the unit output are an insulated neutral
type as required by the National Electrical Code (NEC) article 551.