V&T TS-I Series, Руководство пользователя

Страница: 22 / 79

TS − I Special servo drive for hybrid electro-hydraulic system of injection molding machine User Manual
10 Chapter 2 Installation and connection of servo driver
Figure 2 − 9, and then take out the cover in direction 2.
‹
Mounting of cover
After connecting the cables of main circuit terminals and control circuit terminals, cramp the cover in
direction 1 as shown in Figure 2
− 10, press down the cover in direction 2 and then tighten the cover
screws.
Figure 2 − 9 Removal of cover Figure 2 − 10 Mounting of cover
‹
Mounting of operation panel
Please refer to 2.3.1 Removal and mounting of operation panel.
"
Note:
Do not directly mount the cover with operation panel on the driver, otherwise, the operation panel will
have poor contact.
2.3.4 Open and Close of Doors of TS − I − 4T176A and Above Power Class Driver with
Sheet-metal Enclosure
‹
Opening of the door
Press the latch following direction 1 in Figure 2 − 11 and open the door following direction 2.
‹
Removal of operation panel
The operation panel is connected to the control board through the standard network cable and will not
interfere with the open/close of the door. To remove the operation panel, refer to section 2.3.1 Removal
and Mounting of Operation Panel
‹
Mounting of cover
After connecting the cables of main circuit terminals and control circuit terminals, close the door following
direction 1 in Figure 2
− 12, and then press down the latch following direction 2 to lock the door.
Figure 2 − 11 opening the door Figure 2 − 12 closing the door