Van Der Stahl PTT-100 V, Руководство по эксплуатации

Страница: 40 / 48

PTT-100V Operating Instructions Ver.4.03E
40
CR2032
㸩
ERROR91
PUSH ENTER KEY
ERROR90
PUSH ENTER KEY
Removing the battery:
Inserting the battery:
You will need: a Philips screwdriver
Replace when: “BATTERY ERROR” is displayed.
The battery works to back up the date and time setting.
When the battery voltage drops, “BATTERY ERROR”
or “TIMER ERROR” will be displayed. When this is
displayed, replace the battery.
Coin Lithium Battery used: CR2032
1
Remove the screws that fix the control unit and
open it. The button-cell battery is located at the
rear side of the control unit.
2
When removing the button cell battery from the
battery case, push the battery further in toward
the back before pushing it upward to remove it.
When inserting the button cell battery, insert
the battery so that the plus (+) side faces
upward in the battery case and that the case and
the battery lie parallel to each other. If the
battery is not level when inserting, it will not
insert properly.
3 After replacing the battery, “TIME ERROR”
will be displayed. Adjust the date and time as
they will be initialized.
13 Maintenance
13-1 Battery replacement
Remove the screws
Top view Side view
Lift up
Insert further
into the back
before lifting it
up.
Battery
Insert direction
Insert further
into the back
Case
Side view Rear view
Battery
Plus (+) side
Case
Coin lithium battery
Caution
Always turn the power switch off and
unplug the power cord from the outlet
before replacing parts.
Attention
If the error 90 or 91 is displayed
even after replacing the battery and
adjusting the date and time, the
electric board damage may be
suspected.
Warning
CR Coin Lithium Battery contains
Perchlorate Material – special handling
may apply. California residents, see www.
dtsc.ca.gov/hazardouswaste/perchlorate.
Others, consult local environmental
officers. (U.S.A. ONLY)