Valtra Versu N Series, Руководство оператора

Страница: 112 / 518

CAUTION: If a malfunction occurs in the steering system, stop the
tractor and correct the malfunction before restarting.
NOTE: When the engine is not running, the steering is not power-assisted.
3.8.2 Power shuttle
You can change the driving direction smoothly with the power shuttle lever. The
engagement of the power shuttle is automatic.
You can request a driving direction change with the power shuttle lever at any
driving speed, but the transmission starts to engage the new driving direction only
when the speed is below 10 km/h. If the driving speed is higher, the traction
releases and the transmission goes into idle until the speed is low enough. The
new direction arrow starts to flash to indicate that the driving direction change has
been requested. The direction arrow is constantly lit when the new direction has
engaged. If you return the power shuttle lever to the original direction when the
driving speed is still over 10 km/h, the traction engages immediately.
The operator detector prevents the shuttle engagement if you are not on the seat.
If the direction is selected, the arrow of the selected direction flashes on the
display panel. The selected direction does not engage until you sit on the seat
and move the power shuttle lever to the parking brake position (P) and then to
the desired direction.
If the driving speed is below 5 km/h and the operator leaves the seat for more
than two seconds without pressing the clutch pedal down for more than 10%, the
shuttle disengages and the direction arrow flashes. The direction stays selected
but does not engage until the operator sits on the seat and moves the power
shuttle lever to the parking brake position (P) and then to the desired direction.
DANGER: Do not leave the seat when the tractor is moving.
3.8.3 Parking brake
When the parking brake is on, four-wheel drive (4WD) is engaged and all wheels
brake.
You can use the parking brake by changing the position of the power shuttle
lever. The parking brake engages when driving speed is approximately 3 km/h or
lower.
IMPORTANT: Always apply the parking brake when parking the tractor.
WARNING: If you must leave the cab with the engine running, move
the power shuttle lever to the parking brake position. Always ensure
that the parking brake is actually engaged before leaving the tractor.
WARNING: The parking brake indicator light
P
flashes or message
“PARKING BRAKE FAULT!” is shown on the instrument panel display
3. Operation
- 110 -