VALTIR QuadGuard, Инструкция по сборке

Страница: 29 / 68

Valtir.com 28 Revision D November 2022
8) Attach Fender Panels
Note:
Do not mix the 5/8” rail nuts (large) with the 5/8” hex nuts (small) (Figure 26).
Starting at the Backup, attach left and right Fender Panels shown on page 30 and Fender
Panel Assembly drawing.
Step 1
Place the Fender Panel so that the center of the slot of the rearward Diaphragm is lined
up with the approximate center of the slot in the Fender Panel.
Attach Mushroom Washer Assembly as shown in Figure 27 and Detail 27a and Detail 27b
but do not torque at this time. (This helps to balance the Fender Panel.)
Step 2
Slide the Fender Panel forward until the holes in the Fender Panel line up with the holes
in the forward Diaphragm.
Step 3
Use a drift pin to align the center hole of the Fender Panel with the center hole of the
Diaphragm.
Step 4
Attach the front of the Fender Panels to the next Diaphragm using two (2) rail bolts and
large hex rail nuts per side. Use only the top and bottom holes; leave the center hole open
until the next Fender Panel is attached.
Figure 26
Rail Nuts are Oversize