VALTIR QuadGuard, Инструкция по сборке

Страница: 38 / 68

Valtir.com 37 Revision D November 2022
12) Checking the System Assembly
At this point recheck to ensure that all fasteners are properly tightened throughout the
system ( anchor bolts , etc.). See warning below. Check all Fender Panels. If they do not fit
tightly against the underlying Panel, system realignment may be necessary (Figure 36).
Warning:
Bolt Torque Requirements
Anchor Studs – p. 12
May slightly protrude above nuts
Critical Clearances
Anchor Studs above nuts – Figure 20, p. 25
Fender Panel Gap Narrow – 0.78” [20 mm]
13) Cartridge Assembly
Be sure the Adjustable Cartridge Support in the Nose is attached correctly. See “Attach
Nose Assembly ” in Step 11 on page 33. The top surface of the Nose Cartridge should be
horizontal.
It is the responsibility of the installer to place the appropriate Cartridge in each Bay and
Nose section of the QuadGuard
®
. Type 1 Cartridges are placed toward the front (Nose) of
the system; Type II Cartridges are placed toward the rear (Backup) of the system (p. 38).
Warning:
Placing the wrong Cartridge in the Nose or any Bay is strictly prohibited
pursuant to NCHRP Report 350 testing criteria. Such configurations have not been
accepted for use and may result in unacceptable crash performance.
Figure 36
Fender Panel Gap for Narrow Systems