Page 53
Chapter X Other Settings and Instructions
1:Instructions on material setting
For better printing effect of different materials, temperature and transfer voltage shall be regulated as
follows:
LPU setting
Corresponding temperature
Corresponding voltage
Ultra-low temperature 1
153
Common paper
Ultra-low temperature 2
153
Thick paper 1
Ultra-low temperature 3
153
Thick paper 2
Low temperature 1
161
Common paper
Low temperature 2
161
Thick paper 1
Low temperature 3
161
Thick paper 2
Medium temperature 1
165
Common paper
Medium temperature 2
165
Thick paper 1
Medium temperature 3
165
Thick paper 2
High temperature 1
172
Common paper
High temperature 2
172
Thick paper 1
High temperature 3
172
Thick paper 2
The temperature in the table is max. transient temperature, and the corresponding voltage is set in the
engine.
In case of any of the following faults, please check the paper setting of the printer is correct. It the paper
setting is correct and
the fault still exists, then the image transmission voltage may be incorrect. In such case, please follow below
steps and adjust
the voltage value.
There is white spot on the image (lower voltage)
The ink powder spread around the image (increase the voltage)
The overall image is bluish (increase the voltage)
You can adjust the image transmission voltage for each paper type from 1 to 16. The factory default value is
[6].
1. Press <specification setting> on the engine panel to show menu page.
2. Press <down> to show [administrator menu].
3. Press <left> or <OK> to select and show [network/port].
4. Press <down> till it shows [definition adjustment]. Press <left> or <OK> to select and show [level
correction].
5. Press <down> till it shows [transfer deviation adjustment]. Press <left> or <OK> to select and show the
page for paper type setting.
6. Press <down> till it shows the proper paper type (e.g. thick paper 1). Press <left> or <OK> to select
and show current setting.
7. Use <up> and <down> to input a new value (e.g. 10), and press <OK> to apply the setting.
8. If you want to adjust the transition voltage of other paper types, please use <left> or <return> to return to
step 8 and continue the other steps.