Page 11
Chapter IV Preparations
4-1: Installation of materials
< PICTURE 4-1 >
Please refer to above flow chart for materials installation. Please install materials in the direction of the arrow
(see Picture 4-1). Install the material in the middle (see picture 4-2). Open unwinding and rewinding rollers
(see Picture 4-3). Pass the paper manually through the tension system and open the side door and engine door
A. Pass the engine door A and cooling system (see Picture 4-4) in the print engine along the red path. Close the
engine door A in the side door (not too tightly) and pass the material to the tension system to put the material
under the Rewinding roller. After conveying the material to the recycling shaft, install the material on the
recycling shaft and press down the unwinding and rewinding rollers. Turn on the main power.
Feedin
g shaft
Rewin
ding
shaft
Direction
Tension
system
Tension
system
Rewinding
roller
Unwinding
roller
Transfer
belt
Cooling
system
Fuser unit
Tracking sensor
Print
engine
