Page 18
Chapter VI Software Installation and Instructions
6-1: Presetting IP address for the first time
To connect withColor DLP VP320C, you need to prepare two static IP addresses in local area network
and two network cables, one for the printer and the other for PC.
Note: IP address, subnet mask and gateway address are subject to network environment. On how to set the address,
please consult your network administrator.
1. On engine control panel, press <specification setting> to show menu page.
2. Press <down> till the [administrator menu] appears. P.S. if you skip the item you want to select, please
press <up> to return to the item.
3. Press <right> or <OK> to select and show [network/port setting]. P.S. if you press the <right> or <OK>
key on unwanted item, please press <left> or <return> to return. If you want to start from the beginning,
please press <specification setting>.
4. Press <right> or <OK> to select and show [LPD]. Press <down> till it appears [TCP/IP setting].
5. Press <right> or <OK> to select and show [IP mode]. Press <down> till it appears [IPv4 setting].
6. Press <right> or <OK> to select and show [IP address obtaining method]. Press <right> or <OK> to
select ands show current set value. Press <down> till it shows [manual]. Press <OK> to confirm your
selection. If it shows [000.000.000.000], please go to step 8.
7. Press <left> or <return> to return to the [IP address obtain method]. Press <down> to show [IP address].
Press <left> or <OK> to select and show current IP address.
8. Use <up> or <down> and input value in the first space (for example: 192), and then press <left>. Input
the left space in the same way. After completion of the last (the 4th) space (for example: 192.168.0.200),
please press <OK> to confirm your input.
9. If you need to set subnet mask and default gateway, please <return> and go to step 18. If your need to
finish the setting, please go to step 12.
10. Press <down> till it shows <subnet mask> and select by pressing <right> or <OK> to show current
subnet mask. Input subnet mask in the same way with that of the IP address (for example: 255.255.255.000)
and then press <OK> to confirm your input. Press <return> to return to the [subnet mask].
11. Press <down> till it shows <gateway address> and select by pressing <right> or <OK> to show current
gateway address. Input gateway address in the same way with that of the IP address (for example:
192.168.0.1) and then press <OK> to confirm your input.
12. The setting is down. Press <specification setting> to close the menu, and the printing engine will restart
automatically.
13. Record this IP address and you need to input this IP address for installation of the software.
