Valiani OMNIA, Инструкция по эксплуатации и техническому обслуживанию

Страница: 51 / 66

OMNIA
47
Attention: The VersaTool assembly must be completed by reinserting the magnet support (Y) and tightening the screw
(X).
6.7.12 ASSEMBLING THE VERSATOOL HEAD
When mounting a head (W) on the VersaTool, insert it under magnet holder and when it adheres to the flange,
tighten the screw (Z) (Figure 6-29).
6.7.13 DISASSEMBLING THE VERSATOOL HEAD
If it is necessary to replace the head with another one, proceed as follows:
•
Loosen the screw (Z) (Figure 6-29).
•
hold the release tool/fork (1) by its handle and insert it into the slot located in the top part of the head. Holding
the tool with one hand support the release fork tool with the other, insert into the head slot (2) and give it a slight
knock to free the head.
•
This will detach the interchangeable head from the retaining magnets, and it will remain attached to the magnets
of the release tool (3)
•
Pull away the released tool.
•
Fit the most suitable head for the cut ( paragraphs 6.7.12).
W
Z
X
Y
Figure 6-29
Z
Figure 6-30