Valiani OMNIA, Инструкция по эксплуатации и техническому обслуживанию

Страница: 58 / 66

OMNIA
54
Note: To be able to reposition the pull roller in the same position, make a mark (4) on the plate (if not
already present) as shown in figure 8-5.
Loosen the 4 locking bolts (1), then loosen the lock nut (2) and then the adjustment screw (3) until the head rests on
the surface (Pay attention to the sensor cable).
•
Repeat the operation on the opposite side of the table.
•
With the help of pliers or nippers, straighten or cut the hook of the junction pin of the old belt.
1
2 3
4
Cut or straighten the fixing pin /
rod so that it can be pulled out
Figure 8-5
Figure 8-6