Valeport SWiFT, Руководство по эксплуатации

Страница: 51 / 57

Important Information
Page | 47
©
2021
– Valeport Ltd
11.2.4 FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The NINA-B1 series modules are for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
For NINA-B111 an external antenna connector (U.FL. connector) reference design (see the NINA-
B1 Series System Integration Manual [1]) is available and must be followed to comply with the
NINA-B1 FCC/IC modular approval.
Any changes or modifications NOT explicitly APPROVED by u-blox could cause the module to
cease to comply with FCC rules part 15, and thus void the user's authority to operate the
equipment.
11.2.4.1 Cautions
•
Any changes or modification could cause the module to cease to comply with FCC rules part
15 and thus void the user's authority to operate the equipment.
•
§15.407 statement; in case of absence of information to transmit or operational failure, the
NINA-B1 module will automatically discontinue transmission.
11.2.5 Labelling Requirements for End Product
For an end product using the NINA-B1 modules there must be a label containing, at least, the
following information:
This device contains
FCC ID: XPYNINAB1
IC: 8595A-NINAB1
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.