Valeport SWiFT, Руководство по эксплуатации

Страница: 23 / 57

Important Information
Page | 19
©
2021
– Valeport Ltd
The PC Bluetooth Module is configured to automatically establish a connection to its paired SWiFT
whenever it comes into range. The module scans every 10 seconds so may take up to 10 seconds
to connect after the SWiFT is switched on or comes into range. The LED on the module gives an
indication of operational status.
LED Status Operation
Green Not Connected
Purple Scanning for paired instrument
Blue Connected (Flashing - data transfer)
Orange Configuration Mode
Red Error
None Not connected or Drivers not installed correctly
When the connection is established, the Bluetooth symbol on the SWiFT end cap will turn from
green to blue. Ocean software will then be able to communicate and configure the SWiFT over
Bluetooth using the configured COM port. The SWiFT can only maintain one Bluetooth connection
at a time so can either talk to the mobile app OR the module.
6.4 Configuration
For standard operational use a SWiFT should be configured and operated through the Valeport
Ocean PC, iOS or Android App. Advanced setup and operation is covered in a separate SWiFT
integration guide. Contact Valeport support for more information.
See separate Valeport Ocean Software manual.
Your SWiFT Profiler will be factory paired with the Bluetooth module that it is supplied with. If you
cannot communicate with your SWiFT profiler through the Bluetooth module use the Valeport
Bluetooth Configurator App to re-pair the Bluetooth Module with your SWiFT. The Bluetooth
Configurator App is available from http://valeport.download.
There are two user operational modes. Smart Profile and Continuous. The default mode for
profiling operations is Smart Profile.
6.5 Operational Status:
The operational status LED will be solid green when the unit is switched on and not interrupted,
that is, is not in a command mode.
When the unit is on but interrupted the Operational status LED will flash green.
If in an 'interrupted' state and no commands are received after 5 minutes the instrument will
automatically leave the configuration status and reset to an operational mode.
If deployed
in an ‘interrupted’ state, no profile will be recorded.
6.5.1 GPS Status
When the unit is switched on the GPS will immediately search for time and position data
– the GPS
symbol LED will flash green unit a fix is acquired. Once a valid fix has been obtained the LED will
switch to solid green.
If a fix is not acquired, the unit can be deployed but no position information will be recorded in the
data file and the time stamp may be in error.
GPS is not operational when the comms cable is plugged in