USER'S GUIDE____________________________________________________________________
166 _________________________________________________________________ M210704EN-F
Adjusting Temperature using Serial Line
CT
Use the serial line command
CT
to adjust the temperature.
1. Press
the
ADJ
button on the motherboard to open the adjustment
mode.
2.
Remove the probe filter and insert the probe into the reference
temperature.
3. Use
the
CT
command and press
ENTER
. Type
C
and press
ENTER
to check if the reading is stabilized.
4.
Let the reading stabilize, enter the reference temperature after the
question mark and press
ENTER
three times.
When having another reference temperature (2-point calibration)
press
ENTER
twice and insert the probe to the second reference.
When the reading is stabilized, enter the second reference
temperature after the question mark and press
ENTER
. Please,
note that the difference between the two temperature references
must be at least 30 ºC.
Example (one-point adjustment):
>
ct
T : 16.06 Ref1 ?
c
T : 16.06 Ref1 ?
c
T : 16.06 Ref1 ?
c
T : 16.06 Ref1 ?
c
T : 16.06 Ref1 ?
c
T : 16.06 Ref1 ?
16.0
Press any key when ready ...
T : 16.06 Ref2 ?
OK
>
OK indicates that the calibration has succeeded.
5. Press
the
ADJ
button on the motherboard to close the adjustment
mode.
6.
Take the probe out of the reference conditions and replace the
filter.
