Vaderstad CR 1225, Инструкция по эксплуатации

Страница: 21 / 58

Hitching and unhitching
5.3.2 Lights
Figure 5.4
The male connector for the machine lights is connected to
the standard external 7-pole trailer connector on the
tractor.
To improve the reliability of the lighting and ensure a
long lifespan, use modern LEDs.
The low power requirements of LED lights may mean
that the tractor’s monitoring system does not recognise
that the lights are connected to the external trailer
connector. This means that no alert will be issued if the
lighting stops working for any reason, such as e.g. a
damaged cable harness.
It is therefore important to check prior to road
transport that the lighting connections are
properly attached and that all lights are working.
Ensure that the cables are not at risk of being
crushed.
5.3.3 Hose length adjustment
Adjust the hose length using the hose holder.
When the hydraulic hoses are disconnected from the
tractor, they should be secured in the hose holder.
Figure 5.5
5.4 Disconnection and parking
Always park the implement on a level and stable
surface.
1. Secure the support stand.
2. Secure the wheels using the brake pads (B).
Figure 5.6
3. Make sure that you relieve the pressure in the
hydraulic system. Disconnect the hydraulic hoses.
4. Disconnect the lights.
5. Unhitch the machine from the tractor.
5.4.1 Parking with hydraulic support stand
Figure 5.7
To manoeuvre the support stand when parking the
machine, switch the tap from SystemDisc (B) to support
stand position (A). Position of sticker on machine (C).
B
C
A
B
903815-en-gb; 23.09.2021 17