4
vacon
Keypad Remote Control Options
Step 1. Preparing the Host Enclosure (XRKPM, XRKWM, and XRKMK)
Figure 1 on page 5
is a layout for remote keypad assembly mounting.
If you are fabricating a simple remote control station with this option, the following standard enclosure suggestions
are recommended: Hoffman #A1008CHNF or Hammond #1414N4PHI.
WARNING
SENSITIVE EQUIPMENT
The keypad contains static-sensitive components. It should be handled only by a static-safe installer,
using a grounded wrist strap.
Failure to observe this precaution may cause premature equipment failure.
!
DANGER
HAZARDOUS VOLTAGE
• Disconnect all power before servicing a drive unit or its components.
WAIT 5 MINUTES
until the DC
bus capacitors discharge.
• Ensure that any other power sources that may feed control logic have been disconnected.
•
DO NOT
short across DC bus capacitors or touch unshielded components or terminal strip screw
connections with voltage present.
• Install all covers before applying power or starting and stopping the drive.
• The user is responsible for conforming to all applicable code requirements with respect to grounding
all equipment.
• Many parts in this drive, including printed circuit boards, operate at line voltage.
DO NOT TOUCH.
Use only electrically-insulated tools.
Before servicing any drive.
• Disconnect all power.
• Place a “DO NOT TURN ON” label on the drive disconnect.
• Lock the disconnect in the open position.
Failure to observe these precautions will cause shock or burn, resulting in severe personal
injury or death.
!
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
