10
vacon
Keypad Remote Control Options
Step 6. Preparing the Keypad Interface Module (KIM) (XRKWM only)
(Note: You will need to provide a 15-conductor cable for this step.)
1. There are two housings supplied with the kit; only one will fit your AC drive properly. Select the keypad module
housing that physically matches the one you removed in
Step 2
on
page 6.
2. Insert the keypad interface board into the rear of the plastic housing that you selected.
3. Fasten it with the three (3) M2.5 x 6 screws provided, limiting the torque applied to 6 in-lb maximum.
4. Remove the adhesive covering liner from the overlay.
5. Align and adhere the overlay to the front side of the keypad module. Press the part down firmly to ensure
adequate adhesion to the plastic housing.
6. Install the tie wrap provided in the lower portion of the interface board. Connect the customer-supplied 15-
conductor cable within the tie wrap and terminate to TB1 and TB2. Note the wire color assignments: this will
be helpful later in this process (
Step 8
). For your convenience, TB1 and TB2 terminal blocks are removable.
7. Secure the cable shield(s) to Terminal 1.
Figure 6: Preparing the Keypad Interface Module (XRKWM Option)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
