V-TEK OEM TM-50 SMD, Руководство пользователя

Страница: 35 / 112

6174007.fm The OEM TM-50 Controller
Chapter 2: Controller 21
Run
When RUN is selected, this screen (Figure
2.20) will be displayed and the TM-50 will
ready to operate.
The parameters which have been entered are
displayed on the screen along with the running
parts count. The TM-50 will begin to advance
and seal tape when the foot switch is pressed.
Forcing a Seal Stroke
Pressing ENT while in the run screen, or at the
power-up screen will cause the sealer head to
stamp a single seal, without any advance of
the carrier occurring.
Power Recovery
The power recovery feature recovers lost
motion in the event of a power loss. When
the machine loses power during a tape
advance move, the following screen (Figure
2.21) will be displayed when the machine is
power again and Run Mode is entered.
Selecting YES will add the lost move to the
end of the next advance.
Pitch V-TEK Dwell
8 Advance PSA
Speed Stop Count
100 2500
Figure 2.20
Power loss noticed.
Continue last move?
<- No Yes ->
Figure 2.21