V-TEK OEM TM-50 SMD, Руководство пользователя

Страница: 36 / 112

22 OEM TM-50 User’s Guide
Extended Software Option 6174007.fm
Extended Software Option
The extended OEM TM-50 software option
improves on the system control with a number
of additional features.
The menus found in the extended software for
the controller functions the same with the
additional features discussed below.
The opening screen, as shown in Figure 2.22,
includes an option to choose a previously pro-
grammed job configuration. Pressing 0 opens
a screen (Figure 2.23) that allows the user to
enter a job number from 1-64.
The job number chosen must have been fully
programmed and saved prior to calling it up.
Enter the number and press ENT and the sys-
tem will immediately enter the run mode with
all parameters set.
The initial setup screen is slightly different
from that of the standard OEM TM-50 soft-
ware. It is comprised of a two screen menu
shown in Figure 2.24.
While most of the option screens are
unchanged from the standard software
menus, the 7>MODE choice allows extended
features to be accessed.
Selecting 7>MODE from the setup screen will
bring up the menu shown in Figure 2.25.
Selecting either heat or PSA seal will choose
the mode of sealing. An asterisk indicates the
mode currently set.
Pressing 3>SENSORS will bring up the
screen shown in Figure 2.26.
V-TEK TM50
SETUP JOB RUN
<- 0 ->
Figure 2.22
ENTER JOB NUMBER
_____
Figure 2.23
8>STORE AS JOB
9>RUN THESE SETTINGS
1>COUNT 2>PITCH
3>ADVANCE 4>SPEED
5>DWELL 6>JOG
7>MODE NEXT ->
Figure 2.24
1>HEAT SEAL*
2>PSA SEAL
3>SENSORS
4>INTEGRATION
Figure 2.25
1>EPD* 2>TRACK JAM
3>LOW COVER
4>CARRIER MOTION
5>LOW CARRIER
Figure 2.26