V-TEK OEM TM-50 SMD, Руководство пользователя

Страница: 99 / 112

61574415.fm Omron E5GC Temperature Controller
Appendix B: Temperature Controller B- 3
Setting Protection Levels (Figure 1.1)
1. Press and hold the level and mode keys for at least three seconds. The control-
ler will enter Protect Level .
2. The first parameter, Operation/Adjustment Protection , will read as oAPt on the
PV display. It should be set to 0 . If not, make adjustments with the Up or Down
Arrow Keys.
3. Press the Mode Key. This moves to the Initial Setting/Communications Protec-
tion parameter, which will read as iCPt . It should be set to 1 .
4. Press the Mode Key again. This moves to the Setting Changes Protection
parameter, which will read as utPt . It should be set to off .
Initial Settings (Figure 1.2)
1. Press the Level Key for at least three seconds. The PV display will flash after one
second and temperature control will stop. The controller is then in Initial Settings
Level .
2. The Input Type parameter will display as In-T . It should be set to 7 . This setting
corresponds to the J type thermocouple used in V-TEK sealers.
3. Select the Temperature Unit parameter, displayed as d-u , by pressing the Mode
Key. It should set to C , which selects Celsius.
4. Select the Control Period parameter, displayed as CP , by pressing the Mode Key.
It should be set to 5 .
5. Select the Direct/Reverse Operation parameter, displayed as orEu . It should be
set to or-r .
6. Select the PID/On-Off parameter, displayed as CntL . It should be set to Pid .
7. Select the Self-tuning parameter, displayed as St . It should be set to off .
8. Select the Alarm Type parameter, displayed as ALt1 . It should be set to 1 .
9. Select the Set Point High Limiter , displayed as sl-H . It should be set to 850 .
10.Select the Set Point Low Limiter , displayed as sl-L . It should be set to -100 .
Figure 1.1
Figure 1.2