V-TEK OEM TM-50 SMD, Руководство пользователя

Страница: 59 / 112

61685321.fm Operation
Chapter 3: Setup and Operation 45
Check Carrier Tape Alignment
To ensure an accurate count, select a spot on the loading
track as a reference point for the first and last parts
counted. Examples of reference points include the edge
of the stainless steel
Carrier Tape Guide , one of the fas-
tener heads, or the Track Width Lock Knob .
Set the Counter
Set the counter STOP value in the Controller menu to the
batch size to be run, if necessary, and then reset the counter
to zero.
Place Components
1. The integrated place system will place the component in the pocket and advance the tape
accordingly.
2. Observe the carrier tape as it advances to confirm it is moving smoothly into the sealer and
the cover tape is being positioned correctly. Adjust tape advance speed, seal and cover tape as
needed.
3. When the end of the taped carrier reaches the Take-up Reel , attach it to the reel and set the
Take-up Tension Control so that the carrier winds onto the Take-up Reel but does not apply
excessive pressure to the carrier tape.
4. Once all components have been taped or the batch size
has been reached, reset the counter to zero and run out the
amount of empty carrier tape needed to make the reel’s
leader.
Cut the carrier tape and replaced the finished reel with a new
take-up reel. Repeat the above process.
Examples of Ref. Points
Figure 3.19
1>RESET count to 0
2>SET Stop value
REV 2.xx
Figure 3.20
1>RESET count to 0
2>SET Stop value
REV 2.xx
Figure 3.21