UIT2400 INSTRUMENTATION MANUAL REV A, May 2020
17 OF 18
22A. Set Up Procedure:
Allow the computer to assign a com port and install FTDI drivers
manually, as needed. Device drivers are located in C, Program Files, International Light
Technologies, Datalight III, FTDI folder. To install drivers double click driver CDM…..exe
Software manuals for Datalight III can be found on the ILT website:
lighttech.com/support/manuals-documentation
23. Care and Handling:
The UIT2400 internal board is a sensitive electronic device. Due to risk of board damage, only
trained personnel should attempt opening the housing on the UIT2400. Opening the UIT2400
by non-ILT personnel voids all warranties and may adversely affect the calibration of the meter.
Always store the meter in the carrying case when not in use and always ship in the hard plastic
carrying case with protective packing to prevent shock and damage. No items should be place
above or under the meter inside the carrying case. Do not expose meter to, strong levels of
UV, direct sunlight or high heat sources as the internal temperature can rapidly increase and
cause erroneous readings and damage. Do not apply any force to the display. Do not apply
pressure to the meter when the stand is in use.
23A. Operating Temperature:
0-40°C. ILT meters and sensors have a recommended
operating range of 0 to 40°C to assure the accuracy of the calibrated measurements.
23B. Humidity:
0-95% non-condensing.
23C. ESD:
Use basic ESD precautions and practices when handling the device. It is advisable
to discharge any static buildup by touching a grounded conductive surface before making
contact with devices or its connectors.
