32
Create Communication with Receiver: *for P1 (relay 1) access code:
1. Carry keypad to receiver location for programming.
2. Enter Access Code for P1 (relay 1) on the keypad and continue
to press the last key entered (red light blinks).
3. Press P1 (learn button) on the receiver until LD (green light)
comes on and relay clicks.
Create Communication with Receiver: *for P2 (relay 2) access code:
1. Carry keypad to receiver location for programming.
2. Enter Access Code for P2 (relay 2) on the keypad and continue to press the last key entered
(red light blinks).
3. Press P2 (learn button) on the receiver until LD (green light) comes on and relay clicks.
Programming New Master Password: Once created record here for reference __________
NOTE: The Master Password is NOT an access code. This is a MASTER programming code used
to access the programming of the keypad. It is not used to operate the gate.
1. Enter the Master Password “11111”.
2. Enter “8” If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
3. Enter the Master Password (up to 5 digits), if less than 5 digits, “# or B” is required.
4. Enter “8”
5. Enter the Master Password again to verify.
6. Press “8” If correct, 2 short beeps - New Master Password is set (If 1 long beep is heard, start over
with step 1).
Programming Master Password Back to Factory Default: (11111)
1. Enter “11111”.
2. Press “8” (long beep).
3. Enter PUK code. (PUK must be 5 digits).
4. Press “8”.
5. Enter PUK code to confirm.
6. Press “8” (2 beeps) Master password reset complete.
Receiver Programming
Relay P2 programming from momentary to latching mode (to hold gate open)
1. Press the P2 push-button until the green LD light comes on, then release. Green LD light should
be steady. If flashing latch mode is set.
2. If not flashing release P2 immediately and press P1 once.
3. Green LD light should be flashing. Latching mode is set.
Verifying Receiver P2 relay is programmed to latching mode:
1. Press the P2 push-button until the green LD light comes on, then release.
2. Green LD light should be flashing. If green LD light is steady, redo the Receiver Programming
section above.
Deleting Single Access Code:
1. Enter the Master Password.
2. Press the “7” key. If correct, 2 short beeps
(if 1 long beep is heard, start over with step 1)
.
3. Enter the Access Code to be deleted.
4. Press the “7” key.
(cont. next page)
P1 Button
P2 Button
Receiver
