Universal Laser Systems ULS-25, Руководство по эксплуатации

Страница: 67 / 87

67
MAT BOARD
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING 30 100 250 1 .005”
COMMENTS: Engrave unmasked. A low PPI setting is used to prevent discoloration.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR ENGRAVING 5 10 250 1 .005”
COMMENTS:
Engrave unmasked and at a low PPI setting.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR CUTTING 70 10 200 1 .050”
COMMENTS:
Mask on both sides and elevate above the table at least 1/8”. Use a lower PPI
setting to reduce discoloration of the cutting edge.
ADDITIONAL COMMENTS
Mat board (thick cardboard) is an excellent material to use for architectural modeling and for picture
framing. It cuts and engraves very neatly and cleanly. It comes in a variety of shades and colors.
Patterns can be engraved on the surface with a power setting for light engraving which just breaks
through the very thin top layer and exposes the lighter colored underlying substrate. When engraving, a
low
PPI setting is used to prevent overexposure of the underlying substrate material which causes
excessive dark discoloration. Masking is not necessary on the top surface when engraving. When
cutting, both sides might need to be masked and the material elevated above the engraving table. This
will produce an extremely clean edge on both sides of the material.