P O R T A L T I +
Portal Installation Manual
20
Document #: PTL1001
3.5
Network Connection
The Cat 5 cable will need to be terminated at each end with an RJ-45 modular plug. This
termination should be performed by a technician who is experienced in assembling network
cables as a slight misalignment in the wire termination can cause communications problems.
For reference, provides guidelines for terminating a network cable with a modular RJ-45
plug.
The Network (Ethernet) port is located at the bottom edge of the carrier board as shown in
Figure 16. There should be a surge suppressor installed in the Ethernet port. Insert the
terminated CAT 5 cable into the other end of the surge protector. The facility end of the Cat-5
cable connects to one of the LAN ports on the Unitec router. The router’s WAN port should
be connected to the Internet Service device (e.g. DSL or Cable modem). Other Unitec
devices may need to be connected to the router’s LAN ports. Refer to 6 for details on
connecting devices to the router.
Figure 16. Network Port Location
Содержание Portal TI+
