Unitec Portal TI+, Руководство по установке

Страница: 13 / 50

P O R T A L T I +
Portal Installation Manual 9
Document #: PTL1001
When installing the frame in pre-existing concrete, set the frame in the desired location and
mark the location of each leg of the frame. Drill 2 ½ in. diameter by 8 in. deep (minimum)
holes in the concrete for the frame legs. Fill the holes with concrete anchoring cement (such
as Quickrete #1245-20) and insert the base legs. Ensure the frame is level and place the
plastic base cover over the frame after the anchoring cement has set.

Note:

For added security, the base can be filled with concrete. Before doing so however, the
electrical conduits should be extended to the top of the frame. A rope (or similar
material) should be tied around the plastic cover to prevent it from expanding as
concrete is poured.

Before setting the Portal in place, ensure the field-installed wires are routed to a point where
they can be accessed and pulled through the wiring holes on the bottom of the Portal.
Carefully set the Portal on top of the base so the (3) studs of the base pass through the
mounting holes on the bottom of the Portal. Secure the Portal to the studs with the flat
washer, lock washer and hex nut (in that order) supplied with the base. Pull the wires up
through the cable entrance ports on the bottom of the Portal enclosure.
2.4 Brick-In Installation
2.4.1 Brick-in Mounting Options
There are (2) options for bricked-in mounting:

Build the brick enclosure, fill it with concrete, sink the Adaptor Plate with Mounting
Bolts into the wet concrete, let the concrete cure, mount the Portal TI+ unit, and
then finish bricking in the unit.

Install the Curb-Height Steel Frame, attach the Adaptor Plate, build the brick
enclosure around the frame, mount the Portal TI+ unit, and finish bricking in the
unit. For added security, you can fill the brick enclosure with concrete prior to
mounting the Portal TI+ unit.