![background image](http://html.mh-extra.com/html/unitec/portal-ti/portal-ti_installation-manual_844144029.webp)
P O R T A L T I +
Portal Installation Manual
25
Document #: PTL1001
6. Referring to the figure above, connect the wash relay arming wires, the wash relay
common wire, and any spare option relay wires to the appropriate pins, as indicated in
the following table. Use the screwdriver to open and/or secure the manufacturer wash
wires to each of the Unitec relay locations.
Wash Relays
Pin
Signal
Pin 1
Wash Output #1
Pin 2
Wash Output #2
Pin 3
Wash Output #3
Pin 4
Wash Output #4
Pins 5-8
Spare Option Relays (Outputs 5-8
respectively)
Pin 9
Wash Relay Common
Pin 10
N/A
7. Plug the Phoenix connector into the Wash I/O board socket J17.
8. Continue to Wash-In-Use wiring procedures.
3.7.3
Wiring the Wash-In-Use Interface
Note:
Follow local electrical code when wiring the Portal TI+.
Wash equipment requires a reset circuit.
This circuit is generally identified as the “Wash-In-
Use” (WIU) signal. It is not uncommon for values of this voltage to be as much as 115-120
VAC, so it is extremely important to verify that there is no power applied to any of the wash
components before proceeding.
3 . 7 . 3 . 1
P r e p a r a t i o n
Note:
Wash equipment wiring may vary, and not all equipment manufacturers use the wash-
fault interface.
Refer to the manufacturer’s documentation for additional information.
Make sure all power is disconnected from the wash equipment prior to beginning this
procedure.
Содержание Portal TI+
