P n e u m a t i c
C h a i n S a w
5 1 0 2 6 – 5 1 0 2 9
51026_51029_BA_en_Version_05
Page
31
of
34
Troubleshooting
Problem
Cause
Remedy
a Machine does not
start
Air not connected
Connect and open air line
b Machine rotates too
slowly
Operating pressure too low
Increase operating pressure (on
the machine ) to 6 bar
d Other problems
Contact authorized expert
company
Disassembly – Re-assambly
Disassembly and re-assembly: see repair instruction.
Environmental Regulations
When working on or with the equipment, it is imperative to observe all
requirements in regards to waste- disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging
agents, such as
- lubricating grease and oil,
- hydraulic fluid,
- coolant,
- solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in
suitable containers!
Storage
Unused machines and machine tools should be kept in a dry, closed room. Keep them free from
damaging influences such as damp, frost or large temperature fluctuations as well as mechanical
damage
Disposal
Worn/ defect machine tools must be disposed of according to regional/ national specifications.
Fully disassemble machine for the necessary disposal.
Separate materials according to local environmental specifications.
Properly dispose lubricating, cooling or cleaning agents, which are harmful to the environment, in
order to avoid environmental contamination.
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
Translation of the original manual
compiled: 20.04.16