P n e u m a t i c
C h a i n S a w
5 1 0 2 6 – 5 1 0 2 9
51026_51029_BA_en_Version_05
Page
19
of
34
WARNING
Lacking stability
Squeezing of hands and feet!
Prevent machine/ parts from tilting, falling over or falling down during
re-assembly/ disassembly
NOTICE
Spitznas service is at your disposal for all maintenance, upkeep and assembly
work.
Service life and performance of the chain saw are determined by
a) Degree of air purity
b) Lubrication and maintenance
To a) Blow the air hose clear before connecting it to the saw. Install dirt and water separators
upstream of the saw, if it is not possible to prevent the formation of rust and water
condensation in the air distribution lines.
To b) The motor is lubricated by the lubricator installed in the handle. Fill the lubricator with resin-
and acid-free SAE 5W – SAE 10W lubricating oil. Thick flowing oil will clog the vanes and
affect the start-up and performance of the motor. Only proper maintenance can ensure
constant performance, reduction in wear and thus, a decrease in operating costs and an
increase in service life.
We therefore highly recommend installing service units upstream of the machine.
Observe the comments in the information sheet “Maintenance of Pneumatic Tools”!
Closed greased ball bearings must not be flushed.
After use, clean the saw and rinse it with light oil or provide alternate corrosion protection.
Regularly check and clean the air inlet screen.
In winter, or when using very moist air, an antifreeze lubricant, such as BP Energol AX 10,
Kilfrost or Kompranol should be used.
Replace wear parts – in particular the vanes – when necessary.
Vanes are considered worn, if their width is less than 16 mm.
Lubricating the saw chain is done automatically by the second lubricating system.
The oil tank situated in the motor housing, size approx. 250 ccm, has to be filled with chain saw oil
before starting. It contains oil for approx. 2 working hours. You can check, if oil is conveyed to the
chain, by holding running saw with the bar pointing downwards and, if adjustment is correct, an oil
trace will be clearly observed on a light coloured floor or paper.
Use machine oil with adhesive additive of a viscosity of 49-55 c ST (6.5 – 7.5 E) at 50°C (122 F).
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
Translation of the original manual
compiled: 20.04.16