P n e u m a t i c
C h a i n S a w
5 1 0 2 6 – 5 1 0 2 9
51026_51029_BA_en_Version_05
Page
20
of
34
Filling in chain lubricating oil
- Clean the tank screw-cap and the area around, so that the tank cannot get dirty.
- Use a hopper for re-filling of motor oil and chain oil
- Avoid smoking and naked flame
Adjustment of chain lubrication
When having removed the locking screw item 25, you can see the adjusting screw item 23.
The oil delivery is reduced by tightening, when releasing the screw the oil delivery is increased.
In most of the cases, it will be sufficient to tighten or release the screw by 1/4 to 1/2 turn of a thread.
Attention!
Due to risk of injury, the oil adjustment is only done at standstill of the saw.
The oil reservoir has to be tight (pressure admission).
If the flow in the oil tank does not change, lubricating oil delivery can be interrupted.
Check chain lubrication. Clean the oil passages, possibly look for the SPITZNAS service.
Checking the chain lubrication
The chain always has to sling off little oil.
CS Unitec, Inc.
• Toll-free: 800-700-5919 • Ph: 1-203-853-9522 • Email: [email protected] •
www.csunitec.com
Translation of the original manual
compiled: 20.04.16
