Unipulse UPM100, Руководство по эксплуатации

Страница: 36 / 89

27
4 UTM Ⅱ Capacity Setting
27
Chapter
4
e.g.) When set at "2rpm"
Since waiting for pulse detection for the duration of maximum detection time is required when
rotation stops suddenly from high speed status, the previous rotation speed is not updated;
therefore, the display will become 0 rpm after the display of the rotation speed that was last
detected has held for 7.5 seconds.
◇
How to set the minimum input rotation speed
1.
Select UTM
Ⅱ
capacity setting mode.
2.
Set the "(1) UTM Ⅱ capacity setting target selection".
* Performed only when two UTM Ⅱ are connected.
3.
Perform "(2) Zero calibration".
4.
Perform procedure "(3) UTM Ⅱ capacity setting".
5.
Set the "(4) Rated output value setting".
* This setting can be configured only when "----" is selected in "(3) UTM
Ⅱ
capacity
setting".
6.
Set the "(5) Rated capacity value setting".
* This setting can be configured only when "----" is selected in "(3) UTM
Ⅱ
capacity
setting".
7.
Set the "(6) Pulse rate".
* This setting can be configured only when "----" is selected in "(3) UTM
Ⅱ
capacity
setting".
8.
Set the "(7) Absolute value mode".
9.
Set the "Minimum input rotation speed".
Press the keys and select the
minimum input rotation speed (initial
value: 15 or 60).
Press the key to confirm and move
on to the rotation stop mode.
* Press the key to cancel the setting and return to indicated value display.
Rotation suddenly stops
Pulse
Display
3000 rpm
0 rpm
7.5 sec (display retained)
2 rpm pulse does not arrive
V
A VA
var
W
rpm
PF
Nm
V
A VA
var
W
rpm
PF
Nm
V
A VA
var
W
%
PF
V
A
°C
rpm
V
°C
Nm
1
3 2
Σ
1
3 2
Σ
1
3 2
Σ
1
AUX
2 Σ
ALARM
REC FNC
USB RMS
MEAN
△
▽
ENT
ESC