10
Power Up the UDVR
1. Verify that the system is connected to power at the 12V wall outlet and to the
receiver.
2.
Switch the power toggle to the ON position.
3. Once the receiver is powered up, the Uniden logo appears on the screen and
a short beep sounds as the system performs a self check. After a few minutes,
Live view appears as shown from the camera(s) connected.
UDVR Live View
INSTALLING CAMERAS
Note: A professional installation option is available. See the InstallerNet insert.
CAUTION
Each type of camera requires different installation techniques.
For specific installation instructions, check the documentation
supplied with the camera.
Installation Tips
• Test the cameras before permanent installation. Make a plan for camera wire
routing and for camera angle.
• Mount the camera so the lens is away from direct and intense sunlight.
•
Plan to route the wiring so it does not interfere with power lines or telephone lines.
• Ensure that the camera wiring is not exposed or easily cut.
• Mount the camera in an area that is visible, but out of reach.
•
Avoid pointing the camera at a glass window to see outside. This may result in a
bright white ring in the night vision image, as the light from the night vision LEDs
may reflect off the glass.
• Adjust the camera angle so that it covers an area with high traffic.
•
In “high-risk” locations, have multiple cameras point in the same area. This
provides camera redundancy if a vandal attempts to damage the camera.