English - 26
may not be ensured when using this
phone.
FCC PART 15.105(b):
Note: This
equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to part 15
of the FCC Rules. These limits are
designed to provide reasonable protec
-
tion against harmful interference in
a residential installation. This equip
-
ment generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that in
-
terference will not occur in a particu
-
lar installation. If this equipment does
cause harmful interference to radio or
television reception, which can be de
-
termined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
x
Reorient or relocate the receiving
antenna.
x
Increase the separation between the
equipment and receiver.
x
Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
x
Consult the dealer or an experienced
radio/TV technician for help.
FCC RF Exposure Information
This product complies with FCC
radiation exposure limits under the
following conditions:
x
The base must be placed to allow a
minimum of 20 cm (8 inches) between
the antenna and all persons during
normal operation.
x
The base must not be collocated or
operated in conjunction with any other
antenna or transmitter.
x
The handset is designed for body-
worn operation and meets FCC RF
exposure guidelines when used with
any belt clip, carrying case, or other
accessory supplied with this product.
(All necessary accessories are included
in the package; any additional or op
-
tional accessories are not required for
compliance with the guidelines.) Third
party accessories (unless approved by
the manufacturer) should be avoided as
these might not comply with FCC RF
exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specifications.
This is confirmed by the registration
number. The abbreviation
IC
before
the registration number signifies that
registration was performed based on a
Declaration of Conformity indicat
-
ing that Industry Canada technical
specifications were met. It does not
imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence
Number (REN) for this terminal
equipment is marked on the equip
-
ment itself. The REN assigned to
each terminal equipment provides an
indication of the maximum number of
terminals allowed to be connected to
a telephone interface. The termination
on an interface may consist of any
combination of devices subject only
to the requirement that the sum of the
Ringer Equivalence Numbers of all the
devices does not exceed 5.
Radio equipment
The term
IC
before the radio certi
-
fication number only signifies that
Industry Canada technical specifica
-
tions were met. Operation is subject
to the following two conditions: (1)
this device may not cause interference,
and (2) this device must accept any