English - 23
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter
and phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it
off and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that the
leaking vent faces down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers & reconnecting cords.
Resetting Stations
Unplug the base to reset it. Plug it back in after at least a minute.
If you have trouble with a handset or if you want to replace one, clear the
registration information from the base and the handset:
1. Press & hold
End
and
#
at the same time until you see the
System Reset
menu.
2. If you still have the base the handset is registered to, select
Deregister
HS
, then select the handset you want to reset. If you don’t have that base
anymore, select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
Registering Handsets
If you see a “not registered” message on a handset, you must register it to a
base before using it.
1. Place the handset in the base; the display should say
Registering
. If the
handset does not fit in the base, open the base menu and select
Register
Accy
.
2. Press and hold
#
until
Registering
displays on the handset screen.
3. Wait until the display says
Registration Complete
(about 30 seconds),
then pick up the handset and press
Talk/Flash
.
#
If you don’t hear a dial tone or the display says
Registration Failed
,
charge the battery completely, then try again.
