Unicorn ENDAT-586EL, Руководство пользователя

Страница: 44 / 58

User’s Manual 38
Please follow the prompt instructio ns to set-up or change the system configuration.
Note:
Before running the setup program, ensure the adapter driver is not loaded,
otherwise unpredictable results may arise!
The setup program can be set the on board configuration to provide diagnostic
testing. It is for testing the basic function verification, EEPROM data Access,
loopback operation, and the ability to communicate over the network with another
adapter.
To access this program, insert the Driver Diskette into the floppy disk drive and
then type the following at the DOS prompt:
Ø
A:\REST8139.EXE <ENTER>
1. View Current Configuration
This allows you to find the PCI Fast Ethernet adapter current configuration in
your system.
2. Set Up New Configuration
Select New Set Up Configuration option from the main menu
The option settings can be changed, the table shown as below:
Option Default Setting Other Available Settings
Full-duplex Disabled
à
Auto Selection Enable – Forces to full duplex operation
Flow Control TX Enable, RX Enable TX Disable, RX Disable
Note:
Before setting the adapter for full duplex, make sure the hub switch is also
set to full duplex. Before you activate the switching hub to server
connection, make sure the hub switch and adapter are configured for full
duplex.
3. Run Diagnostics
Running diagnostic tests perform a basic function verification for on board LAN
adapters. The basic Diagnostic tests includes: