Unicorn ENDAT-586EL, Руководство пользователя

Страница: 41 / 58

35
The ENDAT-586EL All -In-One motherboard
5-3. Connecting 100Base-TX Fast Ethernet Network
The system board provides an RJ-45 port for connection to 100Base-TX Fast
Ethernet or 10Base-T Ethernet Network with a single connection over unshielded
twisted-pair (UTP). The adapter automatically operates at 10Mbps or 100Mbps
when the appropriate 10/100Base hub be connected.
To connect the adapter to 100Base-TX Fast Ethernet Network, you need a
twisted-pair Category 5 cable with RJ-45 modular jacks at both ends. This cable
can have a maximum length of 300 feet (100 meters).
5-4. Connecting 10Base-T Ethernet Network
To connect the adapter to a 10Base-T Ethernet Network, you need a twisted-pair
Category 3, 4 or 5 cables with RJ-45 modular jacks at both ends. This cable can
have a maximum length of 300 feet (100 meters).
5-5. 10MBase/100Mbase Installation Notice
•
100Mbps network must be shielded twisted-pair (STP) or Category 5
unshielded twisted-pair cable. Do not use a Category 3 or 4 cable for
100Mbps-network operation, it could cause data loss. Category 3 or 4 cable
is good for 10Mbps network only.
•
Category 5 cable is also good for 10Mbps operation. Use UTP Category 5
cable for the versatility to operate the network at either 100Mbps or 10Mbps
speed without changing cable.
•
Two pairs of wiring are required.
•
Depending on building codes, different insulation materials may be required.
Plenum-rated or TEFLON-coated wiring maybe required in some areas
where fire proofing is required.
•
The wire gauge should be between 18 and 26 AWG (Most telephone
installations use 24-gauge wiring).