UltraVision UltraSensor CMD-2, Руководство пользователя

Страница: 28 / 44

Rev 031109
28
Integrating the CMD-Server 24 with your network
The CMD-Server 24 communicates to clients (laptops and PCs) via a Netgear FVS318 router.
Specifically, using a web browser like Microsoft’s Internet Explorer and entering an IP address
will allow you to become a client of the CMD-Server. The IP address of the CMD-Server is
preset to a value of 10.10.0.11 at manufacturing time. However, this can be changed to another
value if the preset address is not compatible with your existing network. If there is no existing
network, the user must purchase a router and configure it to be compatible with the CMD-
Server’s preset IP address, or configure the CMD-Server to be compatible with the router if a
different set of IP addresses is desired.
Changing the CMD-Server IP address
Warning: This procedure should only be attempted by qualified network administrators.
Changing parameters other than those describe in this document can result in a non-functioning
product that must be reset by UltraVision’s Support personnel.
For this procedure you will need a router configured with a subnet of 10.10.0.0 and a subnet
mask of 255.255.255.0 as well as a computer with either a compatible static IP address or a
dynamic one if the router and the computer are setup to use DHCP (note that some systems ship
with a separate Netgear model FVS114 router preconfigured to these settings). Next, connect
both the CMD-Server and computer to the LAN side of the router. On the computer, run Internet
Explorer and login to the CMD-Server router (Netgear model FVS318) by typing
https://10.10.0.11:8080 . It is very important that you include the reference to port 8080 in your
command-line, otherwise you will access the CMD-Server UltraSensor Security System instead
of the Netgear router located inside the CMD-Server. If you entered the command correctly, you
should see a small dialog box prompting you for a username and password as shown below:
The default username is
admin and the
password is generic11.. . You should now
have access to the full web interface of the
Netgear router.